Orders Over $125 Ship FREE (USA)!

0

Your Cart is Empty

About Adhesive Velcro

The Adhesive Velcro Kit comes with 4 sheets of Hook (rough side) and 4 sheets of Loop (soft side) Velcro.

CUT TO SIZE

  • If your gun is a small one, the velcro will likely need to be cut.
  • Cut it before removing the clear plastic backing. 

CLEAN THE SURFACE

  • Clean the holster with dish soap and water or a lens wipe and allow it to dry before bonding.
  • For hard surface application, for best results, bonding is recommended at room temperature of 60 F to 75 F. 
  • Remove the clear plastic and stick the velcro to the holster.
  • Don't worry about the holster grooves or folds. This is industrial strength adhesive. Just press and smooth the velcro down over the holster folds to ensure adhesion. 

    ALLOW IT TO CURE BEFORE USING

    • Achieves 80% bond strength in 1 hour, full strength in 24 hours.
    • Wait 24 hours before using.

    ATTACH THE HOLSTER TO THE LOOP SURFACE

    • Press the holster against the surface, and if it's a bag gun compartment, press and mold the side of the gun compartment against the holster to help the adhesion. 

    MOVE THE HOLSTER AS LITTLE AS POSSIBLE

    • We recommend leaving the holster in in place if possible, for maximum adhesive longevity - just use multiple holsters in the bags you use frequently, and only move the gun from bag to bag. 
    • If you do remove the holster, be gentle - press against the holster side and remove it gently; don't rip it off.